alguin a tenido algun problema con la atualizacion de la ps3 en firmware 4.20???
echo la atualizacion de mi ps3 ahora siempre que insendo la pantalla se queda negra y vene una mensagem q me lo dices: no es posible iniciar, intentei por el modo recovery y mne lo dice la misma mensagem.
alguin puede me echa una mano??
atualizacion ps3 4.20
-
alex-07
higorsantana: Mostrar
parece que algo en el flash "CoreOS" no estara bien, asi entra en el recovery menu:
Installing OFW420 via Recovery o prueba los menu 3. - 5. si despues te funciona la PS3, si no menu 6.
1. With the system in standby mode (RED LIGHT) . Press and hold the power button down until the system turns on and then off again. Release the power button.
2. After about 1 - 2 seconds press and hold the power button again, until you hear 2 consecutive beeps. Release the power button. During this step you will actually here three beeps.
. There will be one single beep then a short delay followed by the 2 consecutive beeps. Only release the the power button after the 2 consecutive beeps.
3. You will then be instructed to plug in a controller, via the usb cord, and press the PS button : "Connect the controller using a USB cable and then press the PS button".
4. At this point the PS3 Recovery Menu will be shown on the screen.
5. Select menu option 6 :
6. System Update
6. Plug USB in, follow on screen instructions.
el usb-stick (format32) y con estas carpeta x:/PS3/UPDATE/PS3UPDAT.PUP .... PS3xxxx.PUP es la OFW420
-
higorsantana
- Hot Gun
- Mensajes: 25
- Registrado: Lun Ene 17, 2011 5:14 pm
gracias por su resposta, ya echo iso ero no me lo dejas entra en modo recovery.
vene en la pantalla la misma mensagem. tene algun otra opcion para se hacer iso?
vene en la pantalla la misma mensagem. tene algun otra opcion para se hacer iso?
-
alex-07
higorsantana: Mostrar
lo unico que te sirve es sacar el dump y comprobarlo, patchear y escribir le al flash denuevo, porque pienso que casi seguro estara un ros vacio o falsos valores en el!
ps3devwiki validation del dump y ejemplos de los valores en el flash nor o nand
-
higorsantana
- Hot Gun
- Mensajes: 25
- Registrado: Lun Ene 17, 2011 5:14 pm
alex-07 escribió:hola,higorsantana: Mostrar
lo unico que te sirve es sacar el dump y comprobarlo, patchear y escribir le al flash denuevo, porque pienso que casi seguro estara un ros vacio o falsos valores en el!
ps3devwiki validation del dump y ejemplos de los valores en el flash nor o nand
gracias amigo, voy buscar las ferramentas para haer iso.
